This kit is used to convert a regular CO2 tank into an anti-siphon tank. Keep the liquid out of your gun by using an anti-siphon tank. Installation Tips: 1. Screw the valve all the way into your gun. 2. Make a mark on the tank to show which end is up. 3. Remove the valve from gun. 4. Insert the compression fitting into the valve. 5. Insert the copper tube into the compression fitting. 6. Tighten the compression fitting to secure the tube in place. 7. Bend the tube upward about 1.5" from the end (for 20oz tank) (less for thinner tanks) (use the mark on your valve to determine what is up) 8. Install the valve into your tank. 9. The bent end should always face up when installed on your gun. This will keep your gun from sucking in liquid when your gun is in the normal firing position. NOTE: ALWAYS use RED loctite on the pin valve threads when screwing it into your tank. Make sure it's on tightly. An improperly installed valve can be very dangerous.
The information above regarding this PAINTBALL: Anti Siphon Kit (tube fitting) is as of 9-11-2005. Please click through for current information and availability. Click here to comment on this featured PAINTBALL: Anti Siphon Kit (tube fitting) or any other Expansion Chambers or to simply post a comment or article related to sporting goods.
In addition to the PAINTBALL: Anti Siphon Kit (tube fitting) on this page and other merchandise in the category of "Expansion Chambers", we offer a number of other Paintball products, as well as a broad line of sporting goods in general.
